I've been putting off getting a track saw forever, but a recent bout of back probs and need to break down some sheet goods pushed me over the edge...besides, Hank has been gloating about his track set up lately.
Part of my desires is to create perfectly "square" corners without the need to go to the table saw. Like many of us, I previously would do a rough breakdown and then take the smaller pieces to the table saw for final dimensions.
TSO sells a square for the track (TSO GRS16) that looks pretty good, but darn pricey.
Anybody doing cabinet final cuts on sheet goods who can comment on the accuracy of using this thing to eliminate going to the table saw?
Part of my desires is to create perfectly "square" corners without the need to go to the table saw. Like many of us, I previously would do a rough breakdown and then take the smaller pieces to the table saw for final dimensions.
TSO sells a square for the track (TSO GRS16) that looks pretty good, but darn pricey.
Anybody doing cabinet final cuts on sheet goods who can comment on the accuracy of using this thing to eliminate going to the table saw?