collector

  1. NCTurner

    Dust Collector

    Dust Collecting system - $65 (Lake Gaston) Date: 2010-07-04, 10:08PM EDT Reply to: sale-7qprd-1825849028@craigslist.org [Errors when replying to ads?] Cummings saw dust collector works great . Call ( 252 ) 257 - 5912 or ( 252 ) 204 - 5591 Thanks Larry Location: Lake Gaston it's NOT ok to...
  2. kooshball

    I wonder what kind of motor I actually have on my HF 2hp dust collector???

    Ok, so the internet and the manual for the 2HP HF dust collector say that my motor is 20a but the machine label says that it is 14a, then I look at the cord and see that it is 16AWG which according to this link is good only for 10a: http://www.epanorama.net/documents/wiring/wire_resistance.html...
  3. Bin-full Window Dust Collector Modification

    Bin-full Window Dust Collector Modification

    Complete JDS Cyclone-II 2HP Cyclone Dust Collector with modified bin-full windows (overview)
  4. Bin-full Window Dust Collector Modification

    Bin-full Window Dust Collector Modification

    Close-up of interior of bin-full windows. Note use of rivets and silicone to seal lexan windows to waste bin.
  5. Bin-full Window Dust Collector Modification

    Bin-full Window Dust Collector Modification

    Interior view of modified waste bin. Also note use of aluminum HVAC tape (with through rivets to provide necessary electrical bond to each stip) used to dissipate/ground unwanted static buildup.
  6. Bin-full Window Dust Collector Modification

    Bin-full Window Dust Collector Modification

    Close-up of exterior of modified waste bin. I installed two pairs of these windows at ~70% full and ~90% Full. By installing a pair of windows at each level you can use a flashlight to visually detect levels well below either window.
  7. Bin-full Window Dust Collector Modification

    Bin-full Window Dust Collector Modification

    General overview of bin-full window modification. Notice the two pairs of windows, providing not only obvious indication at ~70% and ~90% Full, but also allowing the use of a flashlight to view bin status at much lower limits as well.
  8. J

    Peachtree Drill Press Dust Collector

    I got an email from Peachtree about this if anyone is interested. http://www.ptreeusa.com/edirect_062510.htm
  9. S

    Dust collector

    I'm thinking of getting a dust collector. I work in a 3 car garage but only use half of it to work in. I was thinking a just a 1hp and using gates to cut off whats not in use. Think 1 hp is good? I found a deal on one for $100 but at the same time harbor freight has coupons for a 2hp for $140...
  10. S

    Grizzly dust collector - $70 (wake forest)

    not mine! http://raleigh.craigslist.org/tls/1669488663.html Date: 2010-03-30, 10:13PM EDT Reply to: sale-n87pb-1669488663@craigslist.org [Errors when replying to ads?] Grizzly dust collector. hoses and attachments goes with it . Retiring from woodworking after 30 years. best offer. Other...
  11. S

    jET 2 HP. BAG DUST COLLECTOR - $150 (CLAYTON/WENDELL)

    Not Mine! http://raleigh.craigslist.org/tls/1661376107.html jET 2 HP. BAG DUST COLLECTOR - $150 (CLAYTON/WENDELLDate: 2010-03-25, 6:35PM EDT Reply to: sale-65ugu-1661376107@craigslist.org [Errors when replying to ads?] A JET 2 HP. DUST COLLECTOR WITH A 6" PORT FOR PLENTY OF SUCTION...
  12. J

    HF 2hp Dust collector

    H/F has a 2hp dust collector on sale for 139.. Heres the link http://www.harborfreight.com/cpi/ctaf/Category.taf?CategoryID=238&pricetype=
  13. Travis Porter

    Dust Collector full bin sensor

    I have had a few issues with forgetting to check to see if my dust collector is full. To the point that i have overflowed the drum for my cyclone and got the cartridge filter slam packed with wood chips. :embaresse So..... Last year Touchwood came up with what I considered a neat full...
  14. Travis Porter

    Improving dust collector suction

    I have a 3 HP Oneida Super Gorrilla, and although it has been doing a good job, the filter has started getting leaks around the rim. Part of this is my fault as I have overfilled the drum to the point that the filter got full a couple of times.:embaresse So, I ordered a new filter. It...
  15. Dust Collector Setup

    Dust Collector Setup

  16. R

    Delta Model 50-762, Dust Collector, 3 HP, 3 PH

    Factory reconditioned....Delta Model 50-762, Dust Collector, 3 HP, 3 PH $669.95 http://www.redmondmachinery.com/browse.cfm/4,1256.html
  17. D

    Installing a Dust Collector

    I have a small shop where I do small stuff and some turnings on the lathe. My question is I have a dust collector from HF, I know it isn't the best but at the price I could not pass it up. I want to remove the motor and impeller assy and mount it to the block wall to allow room for the chip...
  18. S

    Delta dust collector clogging

    I hace a 720-1 hp and a 750 1 1/2 hp. Both clog rige at the grill that is in front of the impeller blades. I have tried different lents of 4 inch hose and it still clogs. One DC is connected to a Dewalt 13 inch planner and the other is connected to a Powermatic 650 jointer. I am considering...
  19. AngusMac

    Delta 1 Hp Dust Collector (ebay, Charlotte area pickup)

    Not a bad deal for this small dust collector. Auction ends at 8:55 tonight. Local pick up in Charlotte. http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=290399964703&ssPageName=STRK:MEWAX:IT
  20. AngusMac

    Can a dust collector be used as a central vacuum?

    My girlfriend's mother's house was nearly completed when her husband, who designed its vast majority, died suddenly. The house is designed for a central vac system but the central vac itself was never purchased. We've all come upon hard times and it doesn't seem likely that any of us is...

Our Sponsors

LATEST FOR SALE LISTINGS

Top