aligning

  1. Mike Camp

    Aligning Table Saw Fence

    So I've been doing a ton of reading on aligning my new Delta T2 fence (Biesemeyer clone) and I've read in a handful of places that you want the rear of the fence to be about .020" farther away from the blade than the front of the fence. I assume this is to prevent kickback from occurring via the...
  2. TN Woodie

    Aligning Shelix Head on Planer

    After looking carefully at the alignment on the Ridgid jointer I just got, (See Gloat) I wasn't satisfied with the adjustment of the cutters to the table. It seemed to need to be aligned. On the original cutter head, with knives, I understand that the jack screws under the knives would change...
  3. Don Sorensen

    Aligning Casters ?

    Anybody here have a tip/trick, or other clever way to make sure that all four casters on a roll around cabinet are properly aligned? Or is it simply measuring twice with a good square and drilling once? I've got the standard two fixed and two swivel casters - 4 inch, 330 lb solid rubber from...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top