Search results

  1. Denis Buxton

    Optimum height of lathe?

    The basic rule is the lathe center height should be at your elbow. I'm 6' 1" and recently raised my Mini lathe to about elbow height. It was about 1.5 inches lower. It took a little getting used to the new height.
  2. Denis Buxton

    Heat sterilizing lumber?

    Current regulations for heat sterilization of these wood products require holding a center temperature of 133°F for 30 min.
  3. Denis Buxton

    Epoxy Selection

    Hey ! I used the sander to refinish a maple table , since epoxy resin is not resistant to heat, I remember from my own experience when the table had to be ground again for improper grinding with this resin, there are sometimes problems with cracking, but this is not critical.I found the sander...
  4. Denis Buxton

    DIY Solar Install?

    Installing your own solar panels can be a risk to your own personal safety and to your property for two main reasons: the height at which panels are typically installed and the fact that you're working with a complex electrical system. Most solar systems are installed as either a roof mount or a...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top