Search results

New from Charlotte

Welcome... I am up in Huntersville
- Alex_P
- Post #12
- Apr 20, 2020
- Forum: Who We Are
magports

I use these; they rock!
- Alex_P
- Post #4
- Jan 21, 2020
- Forum: General Woodworking
Jet Jointer Calibration

Bob you definitely fit the bill for ’knowing what they’re doing’. Too bad you’re 3hrs away, I could buy another jointer for that trip charge! It’s entirely possible I am clueless when it comes to this piece of equipment. I know a jointer is limited a flat side and a square edge. If I take...
- Alex_P
- Post #8
- Nov 29, 2019
- Forum: Power Tools and Their Use
Jet Jointer Calibration

First time poster... Happy to have found this community! I’m looking for someone in the North Charlotte area that can do a service call to get my Jointer properly calibrated. I’ve tried running the adjustment instructions multiple times and reviewed a lot of different articles about it. After...
- Alex_P
- Thread
- Nov 27, 2019
- Replies: 9
- Forum: Power Tools and Their Use